Emptying The Watertank; Continuous Drainage - Amcor DC 10 Mode D'emploi

ENGLISH
EMPTYING THE WATER TANK
When the water tank is full, the unit will
switch off automatically and the "Water
Full" indicator (6) will illuminate.
At this time, please empty the water tank as
follows:
• Slowly slide out the tank holding both
sides.
• Holding the built-in handle, pull the water
tank slightly up and then pull gently out
for easy removal.
• After the water is emptied, gently push
the water tank back into place checking
the "Water Full" indicator light is off.
If the tank is not in the correct position the
"Water Full" indicator light will stay on.

CONTINUOUS DRAINAGE

Optional: For the continuous drainage
facility please refer to the following:
Remove the water cap from the tube
beneath the unit.
Fit a hose with an inside diameter of 12
mm over the drainage spout.
Pull out the water tank.
Put the water cap from beneath the unit
on the drain hole B found in the tank
compartment.
Ensure the water will always drain away
freely and the hose will remain in place.
Put back the water tank.
Note: In very cold weather conditions,
precautions should be taken to prevent the
drainage hose from freezing.
20