Control Panel "Pc380-Bs; Descriptions - CBE PC380-BS Instructions D'emploi

CONTROL PANEL "PC380-BS"

DESCRIPTIONS

1) 12V button (lights and awning light).
2) Button to switch the pump on and off.
3) Awning light button; this
automatically off when you start up the engine
(it depend on the 12V button).
Button with integrated twilight sensor to set the
4)
intensity of the LED backlighting in a "night"
situation (see also the "TWILIGHT" function).
5) On/off main button (to turn on/off press for 2
seconds) at the start-up the display carries out :
a functioning test and shows all symbols
(including unused symbols).
If the relevant LED is green the control panel is
on, if it is red an alarm is on (batteries, tanks,
etc.).
"PROG" button for system
6)
SETTING).
1 2
1 2
5 6
awning light switches
setting (see
3 4
3 4
7
8
7) Button for the control of fresh and waste water
tank (in %), for fresh water refilling function
operation (see "FRESH WATER TANK REFIL-
LING" function) and for the regolation of the
programmable parameters' setting (see
SETTING).
Button for control of car and leisure batteries
8)
voltage (in Volt), load and recharge current (in
Ampere) for the leisure battery and for the
parameters' setting (see SETTING).
NOTE: The watch is supplied from the leisure battery
(B2). Should B2 be disconnected, the watch
is able to keep working, without visualization,
for about week 2
EN
.
19