Operation; Amplifier; Mp3/Cd Player; Remote Control - Monacor TXA-622CD/SW Mode D'emploi

5 Operation

5.1 Amplifier

Function
1. to switch the unit on / off
2. to switch the internal
speakers on / off
3. Volume for a microphone
or audio unit connected to
the jack MIC / LINE (16)
4. Volume for one or two
wireless microphones
5. Sound for all micro-
phones and an audio unit
connected to the jack
MIC / LINE (16)
6. Volume for the
MP3 / CD player and an
audio unit connected to
the jack LINE IN (21)
7. Sound for the
MP3 / CD player and an
audio unit connected to
the jack LINE IN (21)
Hint: To save battery power, always remember to switch
off the wireless microphones after operation .
5.1.1 Limiter
The red LED LIMITER (29) lights up when the lim-
iter limits the volume at the maximum undistorted
level . If the LED lights permanently, use the control
LEVEL (17 or 21) to reduce the volume .
5.1.2 Volume attenuation during
microphone announcements
During microphone announcements, the volume
of the MP3 / CD player and of the audio unit con-
nected to the jack LINE IN (21) can be attenuated
automatically . This will make it easier to understand
announcements .
1) Use the switch MUSIC RETURN TIME (25) to
attenuate the volume:
LONG After an announcement, the attenua-
tion will be deactivated with a delay .
OFF no attenuation
SHORT After an announcement, the attenua-
tion will be deactivated immediately .
2) Use the control DEPTH (26) to adjust the level of
attenuation . When the control is set to the left
Operating element
switch POWER (28)
switch INTERNAL
SPEAKER (31)
control LEVEL (17)
control
WIRELESS MIC (18)
controls BASS, MIDDLE
and TREBLE (19)
control LEVEL (23)
Note: Either operate
the MP3 / CD player or
the unit connected.
controls BASS and
TREBLE (24)
stop, the volume will not be attenuated . When
the volume is attenuated during an announce-
ment, the green LED on the left of the control
will light up .

5.2 MP3/CD player

5.2.1 Remote control

1) To insert or replace the batteries (2 × 1 .5 V, size
AAA), remove the cover of the battery com-
partment on the rear of the remote control .
Insert the batteries as indicated in the battery
compartment and close the cover .
If the remote control is not in use for a
longer period of time, remove the batteries to
prevent any damage due to battery leakage .
2) When pressing a button on the remote control,
always point the remote control at the sensor
(10) . Make sure that there are no obstacles be-
tween the remote control and the sensor .
3) If the range of the remote control decreases, the
batteries are discharged and must be replaced .
Never put batteries in the household
waste; always take them to a special
waste disposal, e . g . collection container
at your retailer .
5.2.2 Replaying music titles
1) Switch on the active speaker system .
will appear on the display (8) .
2) Insert a CD, lettering facing up, into the slot (1)
until it is pulled in automatically
and / or
connect a USB flash drive* or a hard disk (with
individual power supply, if required) to the USB
port (7) .
and / or
insert a memory card* into the slot SD / MMC
CARD (9), the notched corner of the card to the
right . To remove the card, push the card into the
slot until it disengages .
*
Note: Due to the large number of storage device
manufacturers and device drivers, it cannot be guar-
anteed that all storage media are compatible with the
TXA-622CD / SW .
3) All other functions can be found in the table
on page 14 .
Welcome
13