Maintenance And Cleaning - Wurth Master LS 2 Notice D'utilisation

LS 2 - book Seite 7 Montag, 16. April 2007 8:05 08
Inserting/Replacing Batteries
Insert the batteries into the battery compartment 9.
Observe the correct polarity as indicated in the bat-
tery compartment.
Replace the batteries when the laser beam goes out
during operation.
Always use the same type of batteries and do not use
rechargeable batteries!
When not using for extended periods, remove the
batteries. Danger of corrosion.
Extreme temperatures can considerably impair the
operating duration of the device.
Working Instructions
Horizontal Application
Place the device on the floor and align it to a refer-
ence line with the stop edge 1.
Switch the device on with the On/Off switch 4.
If required, check the vertical projection with the
spirit levels 2 and bring the projection into align-
ment using the levelling dials 5.
Vertical Application
The device can be fastened to smooth surfaces by
means of adherent aides 8 (accessory).
Insert adherent aid into the openings 7 (arrow)
according to the instructions on the packaging.
Align the device to the wall and press both buttons 3
in order for the device to adhere.
Align the laser beam 6 using the levelling dials 5.

Maintenance and Cleaning

Do not use aggressive cleaning agents; use a soft,
moist cloth.
Clean the optics using a cleaning cloth for glasses or
lenses.
Do not attempt to open the device.
If the machine should happen to fail despite the care
taken in manufacture and testing, repair should be car-
ried out by an authorized customer service agent for
Würth power tools.
For all correspondence and spare parts orders, always
include the article number on the type plate of the
machine.
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/partsman-
ager" or ask for a copy at your nearest Würth branch
office.
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Les outils électroportatifs, ainsi que leurs accessoires
et emballages, doivent pouvoir suivre chacun une
voie de recyclage appropriée.
incorporation into national law, power tools that are
no longer suitable for use must be separately col-
lected and sent for recovery in an environmen-
tal-friendly manner.
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization
IEC 61 000-4-2, IEC 61 000-4-3, IEC 61 000-4-8
according to the provisions of the regulations
89/336/EEC.
07
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Disposal
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its
Warranty
documents: EN 55 022,
R. Bauer
7