Machine Setup - Clarke OBS-18 Guide De L'utilisateur

Machine Setup

To prepare the machine for use follow this procedure:
1. Familiarize yourself with the machine. Read all
danger, warning, and caution statements and the
Operation and Parts Manual before operating the
machine. If you or the operator are unable to read
English, have this manual fully explained before
attempting to operate this machine.
2. Install or replace pad. The pad should be replaced
if it has become matted down to a thickness of 3/
8" or less. To install or replace the pad, follow
these instructions:
a.) Lock handle in the upright position.
b.) Tilt the machine back until it fully rests on the
handle.
c.) Standing over the machine, remove existing
pad then center new pad over grip face.
d.) Press pad against grip face until the hooks in
the driver have set in the pad. See figure 3.
e.) Return machine to the upright position.
CAUTION: Damage to the grip face will occur if
the machine is operated without a pad
or with a pad that is 3/8" or thinner.
WARNING: Never put yourself or let others be in
a position to get injured if the
machine should tip or fall, while
replacing the pad or changing
abrasive.
Clarke ® American Sanders Operator's Manual (EN) - OBS-18/18DC
ENGLISH
EN
Figure # 3
- 5 -