Battery Charger Indicator Led's - Wrangler 2016 AB Instructions D'origine

Through the set of 4 dipswitches it is possible to change the charging curve (4 charging curves are available for
Wet and Gel batteries). The set of 4-dip switches are easy to find (located under the round rubber plug next to the
power cord) without opening the charger.
D 1 D 2 for the selection of the CHARGING CURVE
IP IP
D 1 D 2 D
IP IP
ON ON
OFF ON
ON OFF
OFF OFF
**
D
IPSWITCH SETTINGS FOR
*For batteries from manufacturers other than Crown, contact NSS Customer Service for a recommended algorithm.
Not all other manufacturer's batteries are compatible with the chargers supplied on NSS equipment.
The following table details the operation of the three LED's of the CBHD1-XR-P Battery Charger.
SIGNAL (LED)
Red LED on
Yellow LED on
Green LED on
PROBLEMS
The battery charger does not switch on
The charging cycle does not start.
The Yellow LED indicator flashing
Red and Yellow LED flashing
Red and Green LED On or flashing continuously
Red LED flashing
Red, Yellow and Green LED flashing every second
Red, Yellow and Green LED flashing continuously
3 D 4
IP IP
0 - Special Curve for charging CROWN Lead-Acid (wet) batteries.
** **
SETTING FOR NSS 2392111 - BATTERY, WET 12V, 115 AMP/HR
1 – Curve for charging AGM SEALED LEAD-ACID batteries w/float charge.
** **
SETTING FOR NSS 2392731 AGM BATTERY, 12V, 98AMP/HR,
7696501 AGM BATTERY, 12V, 110AMP/HR
** **
2 - Curve for charging typical GEL sealed lead acid batteries.
** **
Wet batteries with float, 3.5A finish, formerly curve #4.
3 -
DIP3 DIP4
AND

Battery Charger Indicator LED's

C
HARGING
6393651 - BATTERY WET, 12V, 130 AMP/HR
DO NOT EFFECT CHARGING CURVE
First and/or second phase of charge in progress
Second or third phase of charge in progress
End of charge or maintenance phase
Check that the plug is connected to the supply mains and
that the circuit breaker is efficient.
Check the connection to the battery and the polarity.
Unsuitable battery (battery voltage lower than 4.0Volts or
higher than 3.0 Volts per cell) or battery not connected or
output short circuit.
Battery voltage higher than 4.0 Volts but lower than 1.4
Volts per cell
Internal overtemperature error (the charger stays on with
output current = 0.0A until the temperature is OK. Then it
restarts the charging process (reset).
Safety timer exceeded.
Internal short circuit (Output overcurrent)
All charging profile parameters are not programmed to the
EEPROM of the charger.
The charging profile parameters of the selected charging
profile are not programmed to the EEPROM of the
charger or charging profile not active.

ON
C
URVE
MEANING
SOLUTIONS AND CHECKS