Mitsubishi Electric CITY MULTI PKFY-P06 NAMU-E Manuel D'installation page 8

3. Installing the indoor unit
I PKFY-P18/P24/P30NFMU-E
1
Fig. 3-18
2
B
C
3
✽
E
Fig. 3-19
I PKFY-P18/P24/P30NFMU-E
1
A
E
3
Fig. 3-20
8
D
D
F
5
4
3
2
1
B
3.10. Preparation for piping connection
Remove the vinyl band that holds the drain piping.
• This vinyl band can be used to temporarily attach the pipes to the mount board
while connecting the left pipe.
Rear, right and lower piping (Fig. 3-18)
1 Remove the right side panel.
Left and left rear piping (Fig. 3-19)
1 Remove the right and left side panels.
2 Remove the five screws indicated by the arrows in the diagram.
3 Remove the left side panel, then the lower panel.
• While pushing up the front lower portion of the side panel (to disengage the side
panel catch from the unit catch), slide the upper portion of the side panel to the left.
• When the indoor unit is already mounted, be sure the unit does not fall from the
mount board.
• For reassembly, put the catch at the front lower portion of the side panel over the
unit body and push it to the right.
∗ Structure of the side panel and the unit body
1. Panel catch engages the unit body catch.
2. Panel catch is put in the unit body hole.
3. Panel catch engages the unit body catch.
4. Sheet metal of the unit body enters the panel.
5. Panel catch enters the unit body hole.
4 The drain hose can be connected at two different positions. Use the most conven-
ient position and, if necessary, exchange the position of the drain pan, rubber plug
and the drain hose. (For connecting instructions, refer to page 11, 12.)
A Right side panel
B Left side panel
C Lower panel
3.11. Mounting the indoor unit (Fig. 3-20)
1 Make sure to hang the metal catches of the indoor unit over the hooks of the
mount board.
2 When the piping has been completed, use the securing screws to fix the indoor
unit on the mount board.
Note:
Check that the catches of the indoor unit securely fit over the hooks of the
mount board.
2
3 The screw indicated by the bold arrow is used only during transportation and
D
should be removed. Remove the screw before installation if there is not enough
C
space at the left side to remove it once the unit has been installed.
A Indoor unit
B Wall fixing bracket ¡
C Hook
D Metal catch of the indoor unit
E Securing screws
D Catch
E Side panel
F Unit body