Proper Use; Delivery Contents; Component Description; Technical Data - ULTIMATE SPEED ULG 3.8 A1 Instructions D'utilisation Et Consignes De Sécurité

Introduction
car battery charger ULG 3.8 A1
introduction
Q
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.

Proper Use

Q
The ULTIMATE SPEED ULG 3.8 A1 is a battery
charger with a pulse trickle charge mode and is
suitable for charging and maintenance charging of
the following 6 V or 12 V lead rechargeable batter-
ies with wet cell or gel electrolyte:
• 6 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 14 Ah to 120 Ah
You can also used it to regenerate completely dis-
charged batteries. The battery charger has protective
circuits to prevent sparking and overheating. Any in-
correct or improper use leads to loss of the warranty.
The manufacturer takes no responsibility for damage(s)
arising out of usage that is contrary to the instructions
laid down. The appliance is not meant for commer-
cial use.

Delivery contents

Q
Check the appliance and all accessories for damage
immediately after unpacking. Do not put a defective
appliance or parts into operation.
1 Charger ULTIMATE SPEED ULG 3.8 A1
2 Quick / contact clamps (1 red, 1 black)
1 Operating manual
42 GB

component description

Q
see Fig. A:
LED display (standby)
1
„6 V" LED display „Mode 1"
2
LED display „Mode 2"
3
LED display „Mode 3"
4
LED display „Mode 4"
5
LED display „incorrect polarity / fault"
6
LED display „fully charged"
7
LED display „Charging process active"
8
Q
Selection button „MODE"
9
see Fig. B:
Charging station
10
Mains lead
11
Mounting holes
12
„+"-Pole connection cable (red), incl. ring shoe
13
„–"-Pole connection cable (black), incl. ring shoe
14
„+"-Pole quick-contact terminal (red), incl. red
15
fixing screw
„–"-Pole quick-contact terminal (black), incl.
16
black fixing screw

Technical Data

Q
Input voltage:
Power consumption:
Reverse current*:
Nominal output voltage: 6 V
Nominal output current: 0.8 A / 3.8 A
Charging voltage:
Charging current:
Battery type:
Temperature (min.):
Temperature (max.):
Housing protection type: IP 65 (dust-tight, protected
Safety class:
220–230–240 V ~
50 / 60 Hz
60 W
< 5 mA (no AC input)
/ 12 V
7.3 V or 14.4 V or 14.7 V
0.8 A ± 10 %
3.8 A ± 10 %
6 V lead-acid battery
1.2 Ah–14 Ah
12 V lead-acid battery
1.2 Ah–120 Ah
0°C
40°C
against water jets)
II /