Eurocave Modulotheque Notice De Montage page 9

16
FR
• Decide where you want the racking to be installed.
• Place the pedestal module(s) on a flat surface.
• Attach the basic module(s) to the wall (from the 2nd one up).
• Do not tighten the screws completely until assembly is
complete.
Pivoting Bottle Holder
(MV211)
Shelves (x2)
(MV7)
Vertical Bottle
Holder
(MV4)
Sliding Shelves
(MV22-221/MV12-121
MV14-141/MV15-151
MV20-201)
Cross Module
(MV18)
Horizontal Bottle
Holder
Feet (x2)
(MV9) (MV5)
C
ONTENT
Feet (MV9) p.04
Pedestal Module p.04
(MV2 / MV2L40)
Basic Module (MV1/ MV1L40) p.05
Corner Pedestal Module p.06
(MV17)
Basic Corner Module (MV16) p.07
Bar Module p.08
(MV6)
Rack Module (MV8) p.09
Cross Module p.10
(MV18)
Shelves (MV10-101/MV22-221/MV12-121/
MV14-141/MV15-151/MV20-201/MVMS10-1/
MVMS15-151/MVMS10L40/MVMS1L40/MV10L40/
p.11
MV101L40)
!!! IMPORTANT !!!
• Do not pull out several shelves at the same time.
• Do not lean on the shelves.
• Do not sit on the bar module shelf.
• Do not climb on the side modules.
Upper Finish (x2)
(MV3)
Basic module
Basic Corner Module
Corner Pedestal Module
Rack Module
(MV8)
Pedestal Module
Upper Finish (MV3)
Shelves
(MV7)
Vertical Bottle Holder (MV4)
Horizontal Bottle Holder
(MV5)
Pivoting Bottle Holder (MV211)
Finishing Plugs
(MV13)
Basic module
(MV1)
40
CM
(MV1L40)
(MV16)
Pads (x10)
(MV13)
Bar Module
(MV6)
Storage Shelf
(MV10-101)
(MV17)
Pedestal Module
(MV2)
40
CM
(MV2L40)
p.12
p.12
p.13
p.13
p.14
p.15
3
GB