Barazza B DRAFT Notice De Montage Et Mode D'emploi page 44

SOFT TOUCH CONTROL WITH DISPLAY AND RECTANGULAR PUSH BUTTONS
It switches the lights on and off.
It switches the motor off.
It increases the speed of the motor.
The highest speed of the motor is shown with
second speed comes automatically.
It reduces the speed of the motor.
TIMER. It activates the hood at speed 1 for 10 minutes after which the
motor stops in automatic way. With timer in function the display is showing
a flashing led point.
AUTOMATIC CONTROL OF GREASE FILTERS AND CARBON FILTERS
The electronic controls with display and rectangular push buttons allow automatic control
of the grease filter and of the carbon filter (only when the hood is used in filtering
version) so that the user does not have to remember when maintanance was last carried
out.
When the grease filters must be cleaned, there is
acoustic signal is issued.
When the carbon filters must be replaced, there is the
an acoustic signal is issued.
TO PUT THE GREASE AND/OR CARBON FILTER CONTROL BACK TO ZERO.
After filter maintanance has been carried out you have to:
Stop the motor (stop position);
Press twice in succession the
the symbol is appearing in the display and a "beep" is issued.
SETTING SUCTION/FILTERING FUNCTION.
The hood is delivered standard as a suction hood (saturation indicator
If you wish to use the hood as filtering (saturation indicator
following:
Press at the same time for ca 5 seconds the push buttons
display you will have the
To reset the hood just for suction use, repeat the above, in the display you will have the
symbol appearing.
Additional Functions: SECONDARY LIGHT.
If you keep on pressing the light Push button
disactivate the secondary lights.
24
push button, to confirm that reset has been made
+
symbol followed by an acoustic signal.
for more than 1 second you activate/or
and after 10 minutes the
flashing in the display and an
letter flashing in the display and
and ) please do the
+
+
).
, in the