Driving Treads - ECOVACS ROBOTICS WINBOT950 Mode D'emploi

4. Maintenance
Edge Detection Sensors
Turn WINBOT over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.

4.3 Driving Treads

Plug WINBOT in. Turn WINBOT over and move
the Power Switch to "
hold the START/PAUSE Button for 5 seconds
to stop the Fan.
ON
Move the Power Switch to the "O" position.
16
EN
" position. Press and
OFF
Squeegee
Turn WINBOT over and wipe the Squeegee
with the provided Finishing Cloth to maintain its
effectiveness.
Inspect the Driving Treads by using the
buttons on the Remote Control. Stop the
Driving Treads if dirt is seen on the Treads.
Clean any dirt on the Driving Treads with the
provided Finishing Cloth.
and