Place Safety Pod - ECOVACS ROBOTICS WINBOT950 Mode D'emploi

3. Operating WINBOT
3 Loop the other end of the Safety
Tether around the Safety Pod's
channel and pull it tight.
* If the length of the power cord restricts WINBOT's movement, a WINBOT Extension Cord can
be used. Disconnect End A and End B, and connect them with both ends of the Extension Cord
respectively and tighten.
* Only one Extension Cord can be used with WINBOT.
3.5 Place the Safety Pod
Wipe the surface of the Safety Pod's suction cup
clean with the provided Finishing Cloth.
If WINBOT is being used to clean an inside window:
Press the Safety Pod FIRMLY on the top corner
of the inside window. Make sure the Safety Pod is
attached securely in place.
If WINBOT is being used to clean an outside
window: Press the Safety Pod FIRMLY on the
inside of the window being cleaned. Make sure the
Safety Pod is attached and securely in place.
10
EN
C
D