Wolkenstein WDW 14-7FI TD Mode D'emploi page 65

Starting of a programme
1. Fill the lower rack first.
2. Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3. During operation the appliance must be supplied with water (full water pressure).
4. Close the door properly while pressing gently. When the door closes properly you
will hear a light KLICK.
5. Press the PROGRAM button to select a programme.
6. Press the OFF button when the programme has ended. Open the door.
How to change a programme
You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been drained.
In such a case you must refill the detergent container.
1. Open the door and press the current programme selection for at least 3 seconds.
2. Set the new programme.
3. Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a) All lights are off = stand-by mode.
b) One light is on = the relevant programme is running.
c) One light flashes = Pause - mode.
How to use 3in1 tabs
1. 3in1 detergents contain a combination of detergent, rinse aid and water softener.
2. The 3in1-programme is an additional function and can be operated in
combination with one of the following 3 programmes only: intensive, eco or light.
3. Check that the water hardness of your water supply meets the information given
on the packaging of the 3in1 detergent.
4. Strictly observe the instructions of the manufacturer of the 3in1 detergent.
5. If a problem occurs when using a 3in1 product for the first time, contact the info-
hotline of the manufacturer of the 3in1 product.
65