Wolkenstein WDW 14-7FI TD Mode D'emploi page 46

1. You must install the condensation strip on the bottom side of the worktop to
protect it from the water vapor released by the appliance. The condensation strip
deflects the water vapor from the worktop.
2. You will find the condensation strip inside your appliance.
3. Clean the bottom side of the worktop properly before you install the
condensation strip.
4. Remove the protective foil from the adhesive surface of the condensation strip.
5. Stick the condensation strip on the bottom side of the worktop.
6. Improper installation of the condensation strip may cause damage to the
worktop.
❖ Required space for the appliance: look at the following figures. The back of the
appliance must face the wall. The appliance must be equipped with an inlet and
outlet hose, which can be installed on the left or right.
1 825-875 mm
2 min. 598 mm
3 100 mm
4 Connections for power cable, water inlet, water outlet
Eqiupment depends on model.
3
Installation of the condensation strip.
(Depending on model)
Condensation strip
.
3
46