Maintenance And After Sales Service - Frigelux Rdp210Bds Manuel D'instructions

Changing the light bulb
Light bulb data: 220-240 V, max. 10 W
To switch off the appliance, set the temperature regulator to position "0".
▪ Unplug the mains plug.
▪ To change the light bulb, undo the screw.
▪ Press the light bulb cover as shown and slide it
backwards.
▪ Change the defective light bulb.
▪ Refit the light bulb cover and the screw.
▪ Put the refrigerator back into operation.
7.

MAINTENANCE AND AFTER SALES SERVICE

Maintenance
This product should be serviced by an authorized engineer and only genuine spare parts
should be used.
Under no circumstances should you attempt to repair the appliance yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning.
Contact the local store where your purchase was made.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty
all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells.
Troubleshooting
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling for service.
Problems
Power cut
Unusual noises
The appliance does not
get cold enough
Your appliance does
not get cold at all
Solutions
If the internal temperature of the Freezer is -18 ℃ or less when
the power returns, your food is safe. The food in your Freezer
will remain frozen for approx 8 hours with the door closed. Do
not open the Freezer door more than necessary.
✓ Check the adjustment of the feet of your appliance and its
stability.
✓ Check that it is not touching a wall.
✓
Check that all the movable parts (trays, racks, etc..) are
securely in place.
✓
Check if the temperature is correct. If this is not the case,
adjust the temperature appropriately.
✓
Make sure that you have not placed a large amount of food
or hot food in your appliance.
✓
Be careful not to open the door too often or leave it open.
✓ Check that the door is closed tightly.
✓
Keep your device away from heat sources.
✓
Make sure that the ventilation around the unit is respected.
✓ Check that your appliance is connected to the electrical
supply.
35