Connecting The Cinch Outputs - Conrad XCA 200 Notice D'emploi

or
Minimum loudspeaker impedance of 4 ohms
Mono-bridge mode XCA 200 and XCA 202 model
Minimum loudspeaker impedance of 4 ohms

Connecting the cinch outputs

Additionally to the loudspeaker outputs, the amplifier is provided with cinch outputs by means of which
the input signal can be fed to other components of the car hi-fi system without using adapters.
For connecting the cinch outputs, use only shielded cinch cables suitable for this
purpose. The use of any other cable may cause interference.
Keep the length of the connection cables as short as possible.
Do not install the cables in the proximity of other cables. Thus, you avoid interface
at the input of the subsequent component.
36