Cleaning The Boiler; Cleaning & Maintenance; Storing The Appliance - Bosch Sensixx DS37-Temp Advanced Notice D'utilisation

5
Calc'n'Clean advanced

Cleaning the Boiler

To extend the life of your steam generator and
to avoid any build up of scale, it is essential that
you rinse out the boiler after several hours of use
(approximately after 50 hours). if the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check carefully that the appliance is cold and
unplugged for more than 2 hours, and that the
water tank (1) is empty.
2. Fix the iron to the stand by inserting the tip
of the iron into the front slot and moving the
fixation lever (11) against the heel of the iron.
3. place your appliance on the edge of your
kitchen sink.
4. Unscrew the filter (12) and take it out.
To wash the filter, you may:
a. place the filter under the water tap and
wash it up until calc residues are removed.
Squeeze the filter as indicated in the
picture 5.
b. immerse the filter in tap water (250 ml)
mixed with a measure (25 ml) of descaling
fluid.
The descaling fluid can be obtained from our
aftersales Service or Specialist outlets:
accessory code (after-
sales)
311144
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water.
6. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
To obtain the best result, we recommend that
this operation is done twice.
Important: before re-closing, make sure no
water remains in the boiler.
7. replace and tighten up the filter.
automatic clean warning
(model dependent)
pilot light (6) will flash indicating that boiler must
be rinsed.
To reset the "Calc'n'Clean" counter, switch
the steam station off twice, keeping it off for
at least 30 seconds each time.
(on → 30s off → on → 30s off → on)
18
B O SC H
name of accessory
(Specialist outlets)
TDZ1101
Cleaning &
6
maintenance
E E
Attention! Risk of burns!
always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. after ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cotton cloth.
3. if the soleplate is soiled with dirt or scale, clean
it with a damp cotton cloth.
4. if the cloth is synthetic, it may melt due to
the high temperature on the soleplate (16).
Switch off the steam and rub off any residue
immediately with a thickly folded, dry cotton
cloth.
5. never use abrasive products or solvents. To
keep the soleplate smooth, you should avoid
hard contact with metal objects. never use
a scouring pad, or chemicals to clean the
soleplate.
7

Storing the appliance

1. Set the main power button to the "0" position
(the red light will go off) and disconnect the
mains cable.
2. always allow the appliance to cool down before
storing it.
3. place the iron on the iron pad (2), standing on
the soleplate, and fix it by inserting the tip of
the iron into the front slot and moving the lock
lever (11) against the heel of the iron.
4. Empty the water tank, store the mains cable on
the cord storage facility and the steam hose in
the storage fixing. Do not wrap the cords too
tight.
5. Hold the iron´s handle when moving the
appliance, as shown in figure 7.