Installation Instructions; Prepare Built-In Microwave/Oven Combination; Remove Oven Door - Jenn-Air JMW2427DB Instructions D'installation

Masquer les pouces Voir aussi pour JMW2427DB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Prepare Built-In Microwave/Oven
Combination
NOTES:
Refer to the following "Installation Instructions" and
the "Installation Instructions" section of the Installation
Instructions provided with your built-in microwave/
oven combination.
Refer and adhere to the "Electrical Requirements" section
and complete the instructions in the "Make Electrical
Connection" section of the Installation Instructions provided
with your built-in microwave/oven combination.
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven on cardboard prior to
installation. Do not use the handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials that
may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Move oven and cardboard close to the oven's final location.

Remove Oven Door

IMPORTANT: Use two hands to remove the oven door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered with
a soft blanket, or use the corner posts from your packaging
material.
2. Fully open the oven door.
4
06-May-2019 13:38:42 EDT | RELEASED

INSTALLATION INSTRUCTIONS

WARNING
Door
Hinges
In some European factories the letter "W" of the part code mentioned herein will be automatically
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
Locked
position
Grip here
to rotate
A. Oven door hinge lock in
locked position
4. Gently start to close the door. The door will stop at a partially
closed position.
5. Using two hands, grasp the edges of the oven door.
Close the oven door slightly past the stop position to take
the weight off of the door hinges, and then pull the oven door
up.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Unlocked
position
B. Oven door hinge lock in
partially unlocked position

Publicité

Table des Matières
loading

Table des Matières