Publicité
+10°C（50°F）to+38°C（100.4°F）
Installation
Important: For electrical connection carefully
follow the instructions given in specific paragraphs.
•Unpack the appliance and check if there is any
damage to it. Do not connect the appliance if it is
damaged. Report possible damage immediately to
the place of purchase. In this case retain all packing
materials.
•During normal operation, the compressor and/or
condenser at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
•Transmitting frequency band(s) and max allowed
transmitting power in the operating frequency
band(s):2400-2483.5MHz, less than or equal to 20dbm.
•This equipment should be installed and operated with
minimum distance 20cm between the radiator & your
body.
Attention:
Keep ventilation openings clear of obstruction.
•Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the power cord is damaged, it must be
replaced by a special cord or assembly available
from the manufacture or its service agent.
•Do not use extension cords or ungrounded (two
prong) adapters.
•If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to wait at
least two hours before connecting the appliance to
allow the oil to flow back in the compressor.
•There are working parts in this product which heat
up. Always ensure that there is adequate ventilation
as a failure to do this will result in component failure
and possible loss. See installation instructions.
•Parts which heat up should not be exposed.
Wherever possible the back of the product should be
near the wall.
Electrical Connection
1. The appliance requires a single phase 115V/60Hz
power supply. It has a power cord that has a 3-prong
grounding plug that minimizes the possibility of
electrical shock. This appliance must be grounded.
Do not remove the grounding prong or modify the
power plug.
2. Do not modify the power plug. The power plug
must be accessible when the appliance is installed.
3. 3. The appliance should not be turned off with a
switch or other device.
4. Make sure that the plug is not squashed or
damaged. Otherwise, it may cause short circuit,
electric shock or overheat and even cause a fire.
5. Do not insert the power plug if the socket is loose,
there is a risk of electric shock or fire.
Publicité
