Publicité
Malfunction
The wine is too warm.
Heavy build up of frost,
possibly also on the
door seal.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature etting.
Water on the floor.
Unable to connect
appliance to WiFi network
Possible Cause
Temperature is not properly adjusted.
Door was open for an extended period.
The appliance is near a heat source.
Door seal is not air tight (possibly after changing
over the hinges).
Appliance is not level.
The appliance is touching the wall or other objects.
A component, e.g. a pipe, on rear of the appliance is
touching another part of the appliance or the wall
This is normal, no error has occurred.
The setting temperature is higher than
the ambient temperature.
Water drain hole is blocked.
The password for home Wi-Fi network was entered incorrectly.
The home Wi-Fi router frequency is not 2.4GHz.
The router and appliance kept far apart causing the poor network.
Remedy
Please look in the "Display
controls" section.
Open the door only as long as
necessary.
Please refer to the "Installing your
new appliance" section.
Carefully warm the leaking
sections of the door seal with a
hair dryer (not hotter than approx.
50 ° C) . At the same time shape
the warmed door seal by hand
such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, bend the
component out of the way
arefully.
The compressor starts after a
period of time.
Set the temperature lower than
the ambient temperature as you
want.
Please refer to the "Cleaning and
care" section.
Make sure the password is correct
and connect again.
The appliance only supports 2.4GHz
radio frequency. Set up a dedicated
2.4GHz Wi-Fi SSID and connect the
appliance to it.
Consider either moving the router
closer to the appliance or purchasing
Wi-Fi range extender and installing it.
15
Publicité
