Vibradorm VFF/CDM-F15-VRT-RGB Mode D'emploi page 8

EN
Operation
Remote control LED
This LED lights up with each press of a
button. If a button is pressed for an exten-
ded period, the LED starts flashing.
Bed adjustment
1
All motors up
2
All motors dowm
3
Bed adjustment - Back up
4
Bed adjustment - Back down
5
Bed adjustment - Legs up
6
Bed adjustment - Legs down
VRT massage
(optional)
For activating the back massage motor,
please briefly press the button
For activating the leg massage motor,
please briefly press the button
appropriate massage motor will start with a
soft vibration. You may intensify it by briefly
pressing the relevant button again up to
four times. An acoustic signal indicates, that
you have set the highest massage intensity.
You may now gradually reduce it again by
pressing the relevant button again up to our
times. As soon as you have set the lowest
massage intensity, an acoustic signal will
sound. If you hold the button down for
approx. 2 seconds, the massage motor is
deactivated. In order to stop all massage
functions, please press the button
Undulating massage programs
8
Massage program 1
9
Massage program 2
10
Massage program 3
In the undulating massage programs, the
massage motor intensity is modified in
cycles. For instance, both motors are regulated upward and down-
ward at the same time.
You may accelerate or slow down the undulating cycle for all
undulating massage programs by pressing the relevant program
button four times.
8
2
1
4
3
6
5
12
.
13
. The
13
12
7
.
Simultaneous operation of two drives
The VFF/CDM-F15-VRT-RGB allows for operating two drives at
the same time. As soon as the teach-in procedure is completed for
LED
both drives, the motor control commands are sent to both drives.
Commands for massage and light are exclusively sent to the drive
tought in first.
This function may only be deactivated by a reset to the
default settings on the remote control and another teach-in
procedure.
The drives are not synchronized for
this function. The drives only ope-
rate at the same time. This means
that the inclinations of the individual
back and leg part motors may differ
in the course of time depending on
the load distribution. In this case,
use the button
completely. The motors should now
move in parallel again.
RGB lighting (optional)
The optional accessory MS0-MD10-VRT-
NLB-RGB allows you for setting accents
by the innovative use of up-to-date and
high-quality lighting with RGB lamps. They
are operated by the
In order to switch on the RGB lamp, briefly
press the button
out by another brief touch of the button.
Use the button
colours as provided for in the control. For
this purpose, briefly press the button in
7
order to change to the next colour.
The standard type of MS0-MD10-VRT-NLB-RGB provides
8
8 colour shades. The colour shades provided for by default
may also be modified by using a mobile app if requested.
9
10
1
to move all up
14 15
and .
14
. The lamp is switched
15
to change the favourite
1
14
15