Connecting The Light Effects - Renkforce 1168975 Notice D'emploi

b) Connecting the light effects
The product is only intended for connection to DMX devices with DMX-512
protocol.
The controller supports the operation of a maximum of 32 devices in a DMX
chain or otherwise will be overloaded.
The DMX chain should not exceed a maximum length of 200 m.
The use of XLR microphone cables can interfere with the DMX signal
transmission. If such is the case, use special DMX high frequency cables.
• Connect the DMX connector (11) to the input of the first DMX light effect.
• Connect the DMX output of the first DMX light effect to the DMX input of the next
DMX light effect.
• Proceed as described above for all remaining light effects.
• Connect an XLR plug with terminator (120 Ω / 0.25 W) to the DMX output of the last
device in the DMX chain between pin 2 and pin 3.
27