Before First Use; Setting The Clock; Priming Your Ninja Hot & Cold Brew System - Ninja CP307C Guide D'utilisation

BEFORE FIRST USE

PLEASE KEEP THIS IMPORTANT SAFEGUARD IN MIND
WHEN USING THE APPLIANCE:
IMPORTANT: DO NOT run the appliance without water.
1 Remove all packaging material and stickers from the brewer.
2 Wash the water reservoir, thermal carafe, removable filter holders, and coffee and tea
permanent filters in warm, soapy water with a soft cloth.
3 Rinse parts and dry thoroughly.
4 Before first use, prime the system by running two Full Carafe, Classic Brew cycles with
water only. After each cycle is complete, discard the water.

SETTING THE CLOCK

1
Plug the power cord into an electrical outlet. The clock will flash on the control panel
to indicate that the time has not been set (Fig. 1).
2 Press the hour (H) or minute (M) button until you reach the current time. The AM or
PM indicator will illuminate on the left side of the display as you are setting the time.
3 After 5 seconds, the clock will stop flashing and the clock will be set.
NOTE: If the clock stops flashing and does not display the correct time of day,
pressing the hour (H) or minute (M) button at any time will cause the clock to flash
again. You can now reprogram the correct time by following the previous steps.
NOTE: If you unplug the brewer or in the event of an extended power loss, you will
need to reset the clock the next time the brewer is plugged in.
Fig. 1
8 1-877-646-5288
PRIMING YOUR
NINJA HOT & COLD BREW SYSTEM™
IMPORTANT:
We recommend fresh, cool, filtered
water. Well water is not recommended.
1 To fill the water reservoir, use the hand
grips to lift it to the right and up off
the brewer (Fig. 2). Flip the reservoir
lid open or remove the entire lid, then
add fresh, filtered water up to, but not
exceeding, the Max Fill line (Fig. 3).
Return the water reservoir to the brewer
(Fig. 4). DO NOT fill water reservoir
with anything other than water, as other
liquids may damage your brewer.
Fig. 2
Fig. 3
Fig. 4
2 Ensure one of the removable filter
holders is nested inside the brew
basket (Fig. 5). Once in place, slide
the brew basket all the way in until
you hear a slight click (Fig. 6).
Fig. 5
Fig. 6
ninjakitchen.com 9