Ayce HSA30 24V Traduction De La Notice Originale page 67

OPERATION
1. Connect battery to hedge trimmer. (Fig.3)
2. Start the hedge trimmer. (Fig.7)
Step 1: Firstly press the switch button (3) until the light of "ECO" is
bright;
Step 2: Activate the safety switch (5) and keep it activated.
Step 3: Activate the switch trigger (2) to start the hedge trimmer, it is
lower speed position;
Step 4: If you want to change the low speed position to high speed
position, press the key "TURBO", it changes to high speed
position; press the key "ECO" again, it changes to low speed.
Note: The hedge trimmer will work when safety switch and switch
trigger are activated at the same time. If one of them is released,
then the blade will stop running.
Indicator ① on the panel also indicates the battery capacity. In use,
all LEDs light up green to indicate high capacity of battery. LEDs go
out one after another to indicate the battery capacity is reducing
gradually. (Fig.7)
Fig.7
3. Stop the hedge trimmer
Release the switch trigger and safety switch to stop the blower. And then
press the switch button to turn off the LEDs.
Warning: To protect the battery against deep discharging, when the battery is
flat, the hedge trimmer will automatically switch off. The blade will stop
moving.
Do not continue to press the switches after an automatic shut-off of the
hedge trimmer. The battery can become damaged. Battery needs to be
re-charged before further use.
1
3
5
2
66 67