Makita DPJ180 Manuel D'instruction page 6

— Accidental re-start preventive function
— Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)" position,
the tool does not start. At this time, the lamp
flickers slowly and this shows that the acciden-
tal re-start preventive function is at work.
— To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
Adjusting the depth of groove
3
2
► 1. Pointer 2. Stopper 3. Adjusting screw 4. Rubber spike
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence between
the sizes marked on the stopper and the biscuit size. Fine
adjustments to the grooving depth can be made by turning the
adjusting screw after loosening the hex nut. This may become
necessary after the blade has been resharpened a few times.
Size on stopper 0 10
Biscuit size 0 10
8 mm 10 mm
Depth of groove
(0.3") (0.4")
* With the rubber spikes removed.
Angle guide
The angle guide height can be moved up and down to adjust
the position of the blade in relation to the top of the workpiece.
1
5
6
7
2
3
► 1. Lock lever 2. Angle guide 3. Knob 4. Scale
5. Pointer 6. Tighten 7. Loosen
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
1
4
20 S D MAX
20 - - -
12.3mm 13 mm 14.7mm 20 mm
(0.48") (0.51") (0.58") (0.8")
4
1
► 1. Knob 2. Down 3. Up 4. Center of blade thickness
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from the
top of the workpiece to the center of the blade thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
• Remove the angle guide according to the need of your
work when using the tool with the angle of the fence
adjusted to other than 0°. When you need to use the
angle guide under the above condition, be sure to
adjust the depth of groove to get a proper depth.
1
*
► 1. Fence 2. Angle scale 3. Lock lever 4. Tighten 5. Loosen
2
3
10mm
10mm
► 1. Lock lever 2. Pointer 3. Angle scale 4. Center of
blade thickness 5. Blade cover
6 ENGLISH
5
4
2
1
4
2
3
4
3
5