Technical Data - DOMUS LINE IR WI-XD Manuel D'installation

INSTALLATION MANUAL

TECHNICAL DATA

- Maximum operating distance 8 metres.
- Battery mod. CR2450 (3V) lithium (Fig.1).
INSTALLATION:
Fix the bracket (A) in the required position using the screws (B) supplied in the
pack (Fig.2)
Check the operating distance according to the indications given in the table in
Fig.3
CAUTION: The sensor must not be installed near electromagnetic or heat
sources or exposed to direct sunlight.
A maximum of 7 IR WI-XD sensors can be applied to a single X-Driver
COUPLING WITH STATIC LIGHT X-DRIVER WITH MODULE CM2-XD (Fig.4):
- Press the X-Driver button (C) until the blue signalling LED comes on and then
press the IR WI-XD (D) button until the signalling LED (E) remains on steady,
then briefly press the button (D) again until the signalling LED (E) flashes.
COUPLING WITH DYNAMIC TW LIGHT X-DRIVER WITH MODULE CM2-XDTW
(Fig.5):
- Press the X-Driver button (C) until the blue signalling LED comes on and then
press the IR WI-XD (D) button until the signalling LED (E) remains on steady,
then briefly press the button (D) again twice until the signalling LED flashes
twice.
EN
LIMIT SWITCH OPERATION x TW STATIC AND DYNAMIC LIGHT:
- Limit switch operation, when the unit door covers the sensor (F) the
luminaires connected to the X-DRIVER switch off, and vice versa when opening
the door they switch on.
To change the operation from LIMIT SWITCH to DIMMER SWITCH briefly press
button (D).
DIMMER SWITCH OPERATION x STATIC LIGHT:
- ON-OFF function: The luminaires connected to X-DRIVER are switched on and
off by briefly moving the hand in front of the sensor (F).
- DIMMER and LEVEL MEMORY functions: Keeping the hand steady in front of
the sensor (F) it is possible to adjust the brightness of the luminaires.
The selected brightness will be stored until the next reset (LEVEL MEMORY).
To change the operation from DIMMER SWITCH to LIMIT SWITCH briefly press
button (D).
COLOUR CHANGE OPERATION x TW DYNAMIC LIGHT:
The luminaires are switched on and off by briefly moving the hand in front of
the sensor (F).
Keeping the hand steady in front of the sensor (F) it is possible to vary the
colour hue of the luminaire, the selected colour will be stored until it is
changed again (Color Memory).
To change the operation from DIMMER SWITCH to LIMIT SWITCH briefly press
button (D).