Before Start-Up - Ecor Pro EPD170LGR Mode D'emploi

INSTALLATION (1)

Before start-up

Location
For best results, run your dehumidifier in a closed
space. Close doors and windows. Place the unit by
a wall, free of obstacles and free of anything that
obstructs the airflow (inlet and outlet).
Position
Always leave the device upright for at least one hour
after transport. Oil from the compressor can then
flow back into the compressor from the cooling coils.
The device must be upright and level.
Discharge hose connection
Your dehumidifier comes with a drainage hose. The
hose can be attached to the unit with a quick con-
nector. Unwind the drainage hose and place the
end into a sink, drain, bucket or outside the area to
be dehumidified where the water can drain away. If
using a bucket, empty the bucket regularly so that it
does not overflow.
NB. Always roll out the drainage hose completely.
Never place the end higher than 3.5 metres. Check
the hose for kinks and obstacles, so that the conden-
sation water is not obstructed in its flow. This pre-
vents leakage from the pump.
7