DeWalt DCR028 Guide D'utilisation page 37

Wireless Certifications and Safety
Information
• This device is either CAN ICES-3(B)/NMB-3(B) or CAN ICES-
5(B)/NMB-5(B) compliant.
• This device complies with Part 15 of the FCC Rules and Industry
Canada License-exempt RSS standard(s). Operation is subject
to the following two conditions: 1) This device may not cause
harmful interference, and 2) This device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna, 2) Increase the
separation between the equipment and receiver, 3) Connect
the equipment into an outlet on a circuit different from that to
which the receiver is connected or 4) Consult the dealer or an
experienced radio/TV technician for help.
• Changes or modifications to this equipment not expressly
approved by the manufacturer could void the user's
authority to operate the device.
FINAL PAGE SIZE: 8.5" x 5.5" (half letter)
• Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
• To comply with FCC and Industry Canada RF exposure
limits for general population/uncontrolled exposure, the
antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operated in
conjunction with any other antenna or transmitter.
For Bluetooth® Products
• When traveling on airlines, be sure to comply with the airline
restrictions on usage of personal electronic devices and
Bluetooth®.
• The out of range alert feature has been designed to act as an
aid to warn against products getting misplaced or stolen. It
is not a security system.
• The connectivity range is up to 100 feet (30.5 meters)
depending on environment and location.
• The shortwave radio frequency signals of a Bluetooth® device
may impair the operation of other electronic and medical
devices (such as pacemakers or hearing aids).
NOTE: The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth®, SIG, Inc. and any use of
such marks is under license. Other trademarks and trade names
are those of their respective owners.
This product complies with these standards when operated with
a 6 foot (1.8 meters) or shorter extension cord.
Stanley Black and Decker, 701 East Joppa Road, Towson, MD 21286
www.stanleyblackanddecker.com
(FEB19) Part No. N591662 Copyright © 2018, 2019
Homologation du matériel sans fil et
informations sécurité
• Cet appareil est conforme à la norme CAN ICES-3(B)/NMB-
3(B) ou CAN ICES-5(B)/NMB-5(B).
• Cet appareil est conforme au paragraphe 15 du règlement
du FCC et à la (aux) norme(s) RSS exempté(s) de licence
d'Industrie Canada. Son utilisation est sujette aux deux
conditions suivantes : 1) Ce dispositif ne doit pas causer
d'interférences nuisibles; et 2) Ce dispositif doit accepter toute
interférence reçue, y compris toute interférence pouvant
causer un fonctionnement indésirable.
Cet équipement a été testé et jugé conforme aux limites propres
aux appareils numériques de Classe B, conformément au
Paragraphe 15 du règlement du FCC. Ces limites sont destinées à
offrir une protection raisonnable contre les interférences nuisibles
d'une installation résidentielle. Cet équipement produit, utilise et
peut émaner des ondes radiofréquences qui, s'il n'est pas installé
et utilisé conformément aux directives, pourront causer des
interférences nuisibles aux communications radio. Cependant, en
fonction des installations réalisées, l'absence d'interférences n'est
pas garantie. Si cet équipement cause des interférences nuisibles
à la réception radio ou télévision (ce qui peut être déterminé par
la mise sous/hors tension de cet équipement) l'utilisateur est
encouragé à tenter de corriger ces interférences en prenant l'une
ou plusieurs des mesures suivantes : 1) Réorienter l'antenne de
réception ou en changer l' e mplacement, 2) Augmenter la distance
entre l' é quipement et le récepteur, 3) Brancher l' é quipement à une
prise située sur un circuit différent de celui sur lequel le récepteur
est connecté, ou 4) Contacter un revendeur ou consulter un
technicien radio/télé qualifié.
• Tout changement ou toute modification à l'appareil qui ne
serait pas expressément approuvé par le fabricant pourra
annuler les droits de l'utilisateur à employer cet équipement.