Husqvarna PP 70 Manuel D'utilisation page 12

Control panel
12
Status
The tool is unknown.
The tool is unknown.
The machine stop button is
pushed down.
The product is in sleep
mode.
Incorrect situation.
Ground fault.
There is a hardware fault.
There is a fault in the con-
nected tool.
No power because the
product is too hot.
Warning: The product can
be too hot (1-phase).
Warning: The product can
be too hot (3-phase).
Step
Speak to a Husqvarna
service agent.
Speak to a Husqvarna
service agent.
Do a reset of the product.
Make sure that the ma-
chine stop button is re-
leased.
1. Restart the product
2. If the product does not
start, speak to a Husq-
varna service agent.
1. Change tool and restart
the product
2. If the product does not
start, speak to a Husq-
varna service agent.
Let the product and the
connected power tool cool
down.
Do a check of the cooling
water. Decrease the load.
Do a check of the cooling
water. Decrease the load.
1244 - 002 - 18.05.2020