Hansgrohe S 04447 0 Série Instructions De Montage / Mode D'emploi / Garantie page 10

7
8
9
10
1
2
3
2
4
1
English
Add ½" to this measurement.
Cut each screw so that it is X + ½" long.
Open the stops.
Install the carrier plate.
Temporarily install the handles.
Turn the pressure balance handle counter-
clockwise as far as it will go.
Measure the temperature of the output water.
If the valve opens through hot, re-
verse the cartridge (see page 14).
If the maximum high temperature is
greater than 120°F or that permitted
by local plumbing code, adjust the
rotational limit stop (see page 16).
Turn the water off.