DOGA DSE Série Manuel D'utilisation page 13

1. Swivel the metal ring until you can see the torque setting slot
Turn the drive of the screwdrivers until you can see the torque setting hole
2. Insert the manual screwdriver in the hole and turn clockwise to increase the torque or counter
clockwise to decrease the torque.
NOTE : Do not connect the tool to the air network during torque setting. Do not compress the spring
to the Maximum. The tools may not shut off. In any case do not over come the torque range indicated
in the catalog.
b) Powerbits installation
1. Pull the quick change chuck
DSE Série 13