Cleaning And Maintenance - Babyauto More Lennox 01 Guide D'installation

steps described in the previous chapter to rotate
the seat 180°.
4. CAR SEAT INSTALLATION
See chapter 3.6 to place the safety seat in the
desired position.
1. Place the help adapters (P) in the Isofix vehicle
anchorage points (Fig.4.1.).
2. Release the Isofix arms (m). Push the Isofix arms
unlocking button (l) on both anchors of the child
seat and pull them out completely by continuing
to press the button.
3. Place the child safety seat on the car seat. Make
sure the support leg is at the right angle and rests
firmly on the floor of the vehicle (see Chap. 3.4)
4. Guide the Isofix system connectors on the child
seat into the insertion guides until they lock
into the Isofix anchorage points in the vehicle
and there is an audible ''click". The Isofix system
indicator will change from red to green when the
child seat is securely locked in place (Fig. 4.4).
5. Push the child safety seat against the car seat
to check that the Isofix system is fully attached,
ensuring that the child safety seat is as close to
22
the car seat as possible.
6. Shake the child safety seat to check it is firmly
anchored and that installation is correct.
4.1 uninstalling the Isofix connectors
1. To release the Isofix connectors, push the button
(l) on both anchors to unlock the Isofix system.
The green indicator will turn red showing the Isofix
arms are opened (Fig. 4.5).
5. FASTENING THE CHILD TO THE SEAT.
gROup 0+/1
only group 0+/1. From 0 to 4 years
approximately. (0-18 Kg)
1. Open the harness and place the child on the seat
following the steps described in chapter 3.1.
2. Adjust the headrest and harness height according
to the child's height. See Chapter 3.3.
3. Lock the harness buckle and make sure the harness is
tight and adjusted to the child's body. See Chapter 3.2
IMPORTANT: DO NOT move the vehicle with the
safety seat in the position shown in Fig. 5.1. The
seat must be rotated to the position for Group 0+
or Group 1 after placing the child on the safety seat.
(fig. 5.2 and 5.3)
IMPORTANT: DO NOT place the safety seat facing
forwards before the child weighs more than 9 Kg.

6. CLEANING AND MAINTENANCE

1. To wash belts and plastic parts, use neutral
detergent and warm water.
2. Ensure that soap does not enter inside the buckle
or metal pieces.
3. Do not use chemical products or bleach on any
part of the child seat.
Washing instrUctions:
- the cover can be removed - dry clean, any solvent
and washed at 30 °c. it
except trichlorethylene.
should only be air-dried.
- do not use a dryer.
- machine wash, cold.
- do not iron.
- do not use bleach.
30 °C
if you have any doubts about using or installing this product,
or you need a replacement part, please get in touch with our
customer service team.
7. GUARANTEE
1. the warranty does not cover defects or failures
caused by inappropriate use or non-compliance with
the installation and maintenance safety standards
described in the instruction guides provided with the
products.
2. total repair of original defects is guaranteed free of
charge.
3. if repairs carried out are not satisfactory and the
product does not meet the optimal conditions for
fulfilling its intended use, the holder of the warranty
shall have the right to substitute the acquired article
with another one of similar characteristics, or have the
price paid returned, in the 2 years following the date of
purchase.
4. the warranty shall be automatically considered void if
the article acquired has been repaired or if an attempt
has been made to repair it by an individual that is not
authorised by our company.
23