Mounting On A Radiator - eQ-3 MAX! Mode D'emploi

two years. A battery symbol (
batteries need to be replaced. After removing the batter-
ies, wait approx. 1 minute before inserting the new ones.
This device does not support battery operation.
Never recharge standard batteries. Doing so will
present a risk of explosion. Do not throw the batter-
ies into a fire. Do not short-circuit batteries.
Once the batteries have been inserted, the radiator
thermostat starts an adapter run. You can confirm this
with the Boost button. For more details, see the next
section 6.
The radiator thermostat can be mounted on all standard
heating valves. There is no need drain away water or to
fiddle around with the heating system. Start by removing
the old thermostat dial.
Turn the thermostat dial
•
anticlockwise as far as it
will go (A).
• Unfasten the thermostat
dial (B).
• Pull the thermostat dial off
the valve (C).
Some valves require the use of an adapter. Adapters
for Danfoss valves (RA, RAV, RAVL) are supplied with
the product. For more details, please see the list of
adapters on page 18.
22

6. Mounting on a radiator

) indicates that the