Instructions For The Installer; Technical Data; Installing The Appliance; Transportation, Unpacking - Zanussi ZRX 7 JB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB

Technical data

Model/Type
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption
Energy class, according to EU standards
Rated power (W)
Weight (kg)

Installing the appliance

Transportation, unpacking

It is recommended to deliver the appliance in
original packaging, in vertical position consider-
ing the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging

Cleaning

Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.

Placement

The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practical
to operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
44
Ins
tr
uctions f
Ins
tr
uctions f
ZRX 7 JB (RB 70 I)
Ice-making comp.: 5
Fresh food comp.: 65
Ice-making comp.: 5
Fresh food comp.: 62
(kWh/24h)
(kWh/year)
.
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... + 38 °C
or the Ins
t
or the Ins
t
525
520
587
0,38
139
A
55
24
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
increasing temperature in the cooling compartment or
increasing energy consumption.
When placing the appliance ensure that it stands level.
Mount the spacers supplied in the plastic bag of the
accessories. Hold the spacer as shown on the Fig.,
using fine strokes of hammer put it in its place.
Do not stand the appliance on a sunny place or close to a
radiator or cooker.
If it is unavoidable because of furnishing and the appli-
ance has to be stood near a cooker take these minimum
distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal dis-
tances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely
aller
aller

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rb 70i

Table des Matières