Electrolux Pedestal Notice D'utilisation page 8

8
HOW TO INSTALL THE STAND ON YOUR WASHING
MACHINE
WARNING! Do not install the
stand on a washer/dryer
column.
CAUTION! If the washing
machine is already
connected to the mains,
proceed as follows:
1. pull out the plug from the mains socket;
2. stop water supply by closing the tap;
3. disconnect the inlet pipe and the drain
pipe and get ready to collect any water
left in the machine with a shallow basin.
With a brand new washing
machine, do as follows:
1. install the stand before connecting the
machine to water and electricity mains;
2. follow the instructions to remove any
transport safety equipment.
Before you start installing the stand on
your washing machine:
1. make sure you have plenty of room.
Avoid working in restricted spaces as
the installation and subsequent
To install the stand proceed as follows:
adjustment operations may turn out
quite awkward and difficult to carry out;
2. take the stand out of its package and
use the cardboard to rest washing
machine and stand on, so you won't
scratch the equipment varnish and the
floor;
3. in the stands drawer you will find an
envelope with all the necessary material
for a correct assembly;
4. have ready a Phillips screwdriver to fit
rear brackets to the stand.
The pack includes:
• 2 front rubber feet (for tumble dryer
only);
• 4 rear metal brackets (2 for washing
machine and 2 for tumble dryer);
• 6 self-tapping screws (4.2 x 13 mm);
• 1 key to adjust stand feet.
Before starting the installation,
adjust the stand's feet in order
to achieve a perfectly stable
horizontal position.
1. Loosen the nuts using the key supplied with the
stand.
2. Adjust the feet to allow for an uneven floor.
3. Tighten up all check nuts.
4. Fit one of the rear brackets to the left side of the
stands back using the screws supplied.