Publicité
Les langues disponibles
Les langues disponibles
10
HOW TO INSTALL THE STAND ON YOUR TUMBLE DRYER
WARNING! Do not install the
stand on a washer/dryer
column.
CAUTION! If the tumble dryer
is already connected to the
mains, proceed as follows:
1. pull out the plug from the mains;
2. remove the condensation tank found in
the upper or alternatively lower part of
the tumble dryer (according to machine
type) and empty it, if necessary;
3. drain off any condensation water
through the hose found on the lower
part of the machines back (see the
below figure).
Place a mop on the floor and remove
first the clamp (A) using a pair of pliers,
then the cap (B). Tilt the machine
slightly on one side. When all the water
has drained off, put the cap back onto
the hose and re-fasten the clamp.
11. The stands drawer, with a capacity of up to 20
kg, contains two dividers; they may be taken out if
you wish. The drawer was designed with a special
compartment inside where you can place a folding
plastic box, supplied, quite useful to store your
washing laundry.
12. The drawer slides on two metal runners and
can easily be pulled out to the full. Should you wish
to remove the drawer, you must pull it out
completely and act on the two black plastic levers
halfway through the metal runners. Pull the right
lever up and the left lever down: the drawer will be
uncoupled from the runners and easily removed.
WARNING! Do not place any
solvent or flammable substance
into the drawer, as the fumes
could be a possible cause of fire.
With a brand new tumble
dryer, do as follows:
1. install the stand before connecting the
machine to the mains.
2. follow the instructions to remove any
transport safety equipment.
Before you start fitting the stand to the
machine:
1. make sure you have plenty of room.
Avoid working in restricted spaces as
the installation and subsequent
adjustment operations may turn out
quite awkward and difficult to carry out;
2. Take the stand out of its package and
use the cardboard to rest machine and
A
B
Publicité
