Electrolux Pedestal Notice D'utilisation page 11

stand on, so you wont scratch the
equipment varnish and the floor.
3. In the stands drawer you will find an
envelope with all the necessary material
for a correct assembly.
4. Have ready a Phillips screwdriver to fit
rear brackets to the stand and an Torx
screwdriver to fit rear brackets to the
machines back.
The pack includes:
• 2 grey short rubber feet to be used for
the following tumble dryer models:
To install the stand proceed as follows:
1
1
2
2
• 4 rear metal brackets (2 for washing
machine and 2 for tumble dryer) ;
• 6 self-tapping screws (4.2 x 13 mm);
• 1 key to adjust the stands feet.
Before starting the installation,
adjust the stand's feet in order
to achieve a perfectly stable
horizontal position.
1. Loosen the nuts using the key supplied with the
stand.
2. Adjust the feet to allow for an uneven floor.
3. Tighten up all check nuts.
4. Lay the machine on its left side, making sure
you do not damage it. Remove the front feet and
replace them with the rubber ones.
5. Tighten the back feet.
WARNING! If you install the
stand under an energy saver
model Class A, you must not use
the tumble dryer immediately.
Please wait 8 hours at least. For
more detailed information, read
the appliance user manual
carefully.
11