Truvox International Orbis OBF431500 Manuel D'utilisation page 3

16. CAUTION - This machine is for dry indoor use only and
should not be used or stored outdoors in wet conditions.
17. DO NOT use where hazardous dust is present.
18. DO NOT use in an explosive atmosphere.
19. DO NOT pick up or use near flammable or combustible
fluids, hazardous dusts or vapours.
20. Do not use to pick up moisture or any liquids
21. CAUTION - If it is suspected that there is hazardous dust or
flammable materials stop cleaning the area immediately
and consult your superior.
22. DO NOT use to clean up any burning or lighted materials
such as cigarettes, matches, ashes or other combustible
objects.
23. Take care when using a machine near the top of stairs to
avoid overbalancing.
24. DO NOT put any object into openings. DO NOT use with
any opening blocked; keep free of dust, debris and anything
that may reduce airflow.
25. DO NOT cover the machine when in use.
26. Keep hair, loose clothing, hands, feet and all other parts of
the body away from openings and moving parts.
27. DO NOT use if it has been damaged, left outdoors or
dropped in water.
28. Do not operate the machine with a damaged supply lead or
plug, or after the machine malfunctions or is damaged in
any way. Contact an authorised Service Agent for repair or
adjustment.
29. Only replace the supply cord with the type specified in the
instruction manual.
30. This machine should always be connected to a fully earthed
power supply of the right voltage and frequency.
31. DO NOT leave machine running unattended.
32. Do not leave the machine connected to the electricity
supply when not in use, always remove the plug from the
socket-outlet.
33. Switch off the machine before removing the plug.
34. When unplugging, pull the plug, not the supply cord.
35. The machine shall be disconnected from its power source
when not in use and before commencing cleaning of the
machine or maintenance and when replacing parts or
accessories, by removing the plug from the socket-outlet.
36. DO NOT pull or carry by the supply cord. DO NOT use cord
as a handle, close door on cord or pull cord around sharp
edges or corners.
37. WARNING: Keep the supply cord clear of moving parts.
38. DO NOT kink or twist the supply cord and keep cord away
from heated surfaces.
39. DO NOT operate switches or touch the mains plug with wet
hands as this may cause electric shock.
40. The power supply cord plus any extension leads should not
exceed 30 metres in total. The cross section of an
extension cable wiring must be at least 2.5mm².
CONTROLS ON THE MACHINE
The operating controls for all models are located on the handle
(Fig 1 ).
3
Fig 1
1 - Switch trigger, left hand
Used to switch motor ON and OFF. Can only be operated with
handle in working position, and if left hand interlock button (2)
has previously been depressed
2 - Interlock button, left hand
This must be depressed initially to enable left hand switch
trigger to switch motor on.
3 - Switch trigger, right hand
Used to switch motor ON and OFF. Can only be operated with
handle in working position, and if right hand interlock button (4)
has previously been depressed.
4 - Interlock button, right hand
This must be depressed initially to enable right hand switch
trigger to switch motor on.
5 - Handle adjustment lever
Used to adjust handle to comfortable working height. Note: For
safety reasons the machine cannot be operated unless the
handle is moved to a working height.
Cable winder
Used to hold supply cord in place on handle when machine is
not in use.
Neon indicator (on handle)
Lights when the machine is connected to the power supply.
Fitting pads
WARNING - This appliance has been designed for
use with the pads specified by the manufacturer.
The fitting of
performance and safety.
Always ensure machine is unplugged before fitting or removing
parts.
• Raise cleaning head by pulling handle backwards to rest on
the floor.
• Unscrew central pad lock and remove.
• Press cleaning pad onto drive disc, refit pad lock and tighten
(Fig 2).
• Return machine to upright position.
• IMPORTANT - Never allow the cleaning head to rest on
the pad when not in use.
Adjusting the handle height
Select the most comfortable handle height using the
adjustment lever as previously described (see Controls) and
lock in position.
Operation
Starting the machine
• Fully unwind the supply cord from the handle and plug in to
a convenient socket outlet. The neon indicator on the handle
should light showing that power is available.
• With the handle set at a convenient working height and with
both left and right hands on the handle, depress both
interlock buttons with the thumbs and squeeze both switch
triggers to start the machine (Fig 2).
other pads may affect
Fig 2
its