Installation - Warn Pn81809 Instructions D'installation

VI. INSTALLATION:
1. Remove factory front a-arm guard, if
applicable.
2. Fasten guard (A1) to flange on A-Arm using M6
screws (B1). Do not tighten. (Figure 2)
3. Align guard as needed. Tighten all fasteners to
torque specifications listed above.
4. Repeat steps one through three for installing
guard (A2) on other A-Arm.
WARN INDUSTRIES
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
M6 Screws
PAGE 4
Figure 1
Figure 2
78447A2