tbs electronics Omnicharge DC OCD12/12-50 Mode D'emploi page 13

Invalid battery type settings can cause serious damage to your batteries and/or
connected battery loads. Always consult your battery's documentation for the
correct charge voltage settings.

The remaining connection options are shown below
The optional QuickLink communication Kits allow the charger to be programmed and
monitored using the TBS Dashboard software on PC (via USB or RS232) or the
Dashboard Mobile app on iOS and Android platforms (via Bluetooth).
Always connect the battery temperature sensor to the battery that is being charged
(output battery). The charger automatically compensates the charge voltages against
battery temperature. This means that the charge voltages are slightly increased at
lower temperatures and decreased at higher temperatures (-30mV/°C at 12V chargers
and -60mV/°C at 24V chargers). This way, overcharging is prevented which prolongs
your battery's lifetime. When the LiFePo4 charge program is selected, the charge
(see point 3 above). When this DIP switch is set to On
(default setting), the On/Off control input is bypassed and
the charger will always operate, independent of the status at
the control input. When this DIP switch is set to Off, the
charger is controlled by the On/Off control input. This
setting is recommended for vehicle applications with a
proper engine run signal.
!
CAUTION
12