Various Sawing Processes; One-Step Sawing; Safety; Maintenance - B+BTec Diamond3 250RS Série Manuel D'utilisation

DIAMOND3
• Clean the saw flanges .
• Fit the saw blade on the centre ring of
the motor flange . (Check the direction
of rotation and make sure the blade is
well centred.)
• Mount saw flange and tighten with the
hexagon nut .
VARIOUS SAWING
PROCESSES

One-step sawing

(Use only original saw blades as advised
by the manufacturer)
• Move saw head down until the saw is
approx . 10 mm . below the saw table .
• Secure saw head with the knob .
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Hold material to be cut with one hand
while making sure your hand is not to
close to the saw blade .
• Pull the saw head with medium force
with the other hand through the
material .
Multiple-step sawing
During this sawing process the saw is
positioned at the desired height and
moved back and forth through the material
to be cut until after a number of steps it is
completely cut through .
• Place the material to be cut on the
250 RS SERIES
®
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Position the saw head at the desired
height .
• Hold material to be cut with one hand
while making sure your hand is not to
close to the saw blade .
• Switch the machine on and pull the
saw head with medium force with the
other hand through the material .

SAFETY

In addition to the valid safety regulations
attention to the following items should be
made:
• Carefully follow the directions of set-
ting up and working with the sawing
machine .
• Carefully check that the electrical con-
nections are correct .
• Electrical cables should not come in
contact with water or water spray .
• Damaged saw blades should be
replaced immediately .
• Secure material to be cut by hand dur-
ing sawing .
• Make sure your hands stay away as
far as possible from the rotating saw
blade .
• Wear protective goggles during
sawing .
• Wear hearing protection during
sawing .

MAINTENANCE

• The cooling water should be replaced
and/or replenished regularly .
• It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis . For example,
place the pomp in a bucket of clean
water after the sawing job and run the
19
GB