Environmental Protection; Troubleshooting - B+BTec Diamond3 250RS Série Manuel D'utilisation

GB
machine for a minute or so . This also
guarantees a longer lifetime of the
pump .
• When the machine is not used for a
longer period of time, the pump should
not remain in the muddy cooling
water . It is better to clean the pump as
described above and leave it outside
the water container .
• Regularly check the saw flanges for
wearing out and replace if necessary .
Diamond blade dressing
Diamond blades performs best when they
are dressed .
After time and use, diamonds on the outer
edge of the blade might become glazed
Problem
The machine
doesn't start .
DIAMOND3
Cause
The power supply cable is
damaged or not properly
connected .
No voltage in the power outlet .
Start switch is damaged .
250 RS SERIES
®
or dull . This will reduce cutting efficiency
and possibly cause the blade to bend .
As a result the cut will not be straight and
mis-aligned . When this occurs, the blade
needs to be dressed .
The diamond blade can be dressed with a
dressing stick .
Dressing procedure(s):
• Place a dressing stick on the saw table
• Make approx . 10 cuts through the
dressing stick .
The diamond blade should be sharp again
and ready for further efficient cutting .
ENVIRONMENTAL
PROTECTION
Do not dispose of the appliance
with domestic waste . Dispose of
the appliance only via an
authorized waste management
company or your municipal
waste management organisation . Adhere
also to the applicable regulations . In case
of doubt refer to your waste management
organisation . Recycle all packaging
material in an environmentally friendly
manner .

TROUBLESHOOTING

For malfunctions that are not specified
in this chapter, when in doubt or when
explicitly indicated, seek assistance from
an authorized service facility .
Solution
Press the plug firmly in the power
outlet . Check the power supply
cable .
Have the power outlet checked .
Have the switch replaced .
20