Characteristics; Unpacking And Set Up - B+BTec Diamond3 250RS Série Manuel D'utilisation

DIAMOND3
Non-grounded common household or
similar power outlets are not suited as a
power source .
For water cooled sawing machines
stricter safety standards are applicable .
Therefore, for extra safety the machine
must be connected according to one of the
following methods:
• Main power supply equipped with
earthleak switch 30 mA .
– or –
• Separating transformer, only 1
machine may be connected at any
given time
– or –
• With an intermediate cable equipped
with a PRCD safety switch of max .
30mA .

CHARACTERISTICS

Machine construction
The stainless steel construction contributes
to a stable, rigid and durable sawing
machine . The 4 detachable legs are to be
installed in the leg sockets at the underside
of the water container and fastened with
the knobs .
Saw head
The saw head is constructed of cast alloy
components . The height adjustment of the
saw head is kept in balance by a spring .
A handle secures the saw head at the
desired height .
Saw cover
The blade guard is a stainless steel plate
cap with a removable blade cover which
is fastened by 3 knobs .
Saw spindle
The motor flange is mounted on the saw
spindle . The saw flange is to be mounted
on the saw spindle with a hexagon nut
to clamp the saw blade . (Attention: Left-
250 RS SERIES
®
handed screw thread.)
Saw table
The cutting table is constructed of
removable aluminum components for
easy maintenance, and a stainless steel
adjustable side stop .
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade . A drain hole, with a plug, is
located in the water container . The mud
flaps prevent most of the water mist and
make sure most water flows back in the
water container .

UNPACKING AND SET UP

Setting up
• Unpack the sawing machine and
inspect for any damaged parts .
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs .
• Level the sawing machine by adjusting
the legs in the sockets and make sure
it is stable .
Saw head
• Unscrew the transportation lock .
• By loosening the handle the saw
head can be positioned at the desired
height .
17
GB