Imer Group JARD 7 EX Manuel D'utilisation page 40

3. Drain the fuel system (see 10.2.);
4. Remove the spark plug;
5. Clean the pump unit with a cloth soaked in oil;
6. Pull the recoil starter rope until you feel a resistance (engine in compression allow to close the
valves and avoid oxidation) and leave the engine in this position;
7. Store the pump in a well-ventilated, clean and dry place.
10.1. EMPTYING THE WATER CIRCUIT
1. Unscrew the drain plug [Fig. 28] and empty completely the pump body [Fig. 29];
2. Remove the priming plug [Fig. 14];
3. Clean the pump body with clear water;
4. Allow water to drain completely;
5. Replace the priming and drain plugs.
10.2. EMPTYING THE FUEL CIRCUIT (GASOLINE)
■ Operation to be avoided in the vicinity of a heat source, open flame or other conditions that may
cause a fire.
■ Do not smoke.
1. Position a container under the tank to collect fuel;
2. Open the tank cap [Fig. 06];
3. Thoroughly let petrol flow out of the tank into a convenient container;
4. Close the tank cap.
40