Intended Use; Mode Function - DeWalt DCR025 Guide D'utilisation

Intended Use

This D WALT Bluetooth® radio/charger is designed for
e
broadcast radio reception or to play/stream audio via a
wireless Bluetooth® connection or wired connection to a
mobile phone or other audio device and charge D
batteries.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
To Install Coin Cell Battery (Fig. D)

WARNING: Danger of explosion if battery is
incorrectly replaced. When replacing battery, replace
it with the same or equivalent type CR2032. Observe
correct polarity (+ and –) when replacing batteries.
Do not store or carry batteries so that metal objects
can contact exposed battery terminals.
1. On the battery door on the back of the unit, turn the
screw 22 counterclockwise to remove. Screw will
remain captive in the door.
Fig. D
22
2. Press down on the battery door latch and pull to open.
3. Install the coin cell battery
inside the coin cell battery area.
4. Replace the battery door, insert the screw and tighten.
nOTE: To reset the LCD display, clock, and pre-sets remove
the coin cell battery and re-install. Follow this procedure if
the screen seems to lock in place.

DANGER: DO NOT INGEST BATTERY; CHEMICAL
BURN HAZARD. This product contains a coin/
button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just
2 hours and can lead to death.
Keep new and used batteries away from children. If
the battery compartment does not close securely stop
using the product and keep it away from children
If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate
medical attention.
WALT
e
23
23 according to the diagram
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Your Bluetooth® radio/charger is equipped with memory
capacity in order to store the time and your selected
memory channels. When the radio is in the OFF position,
this memory capacity is powered by one coin cell battery
that is included with the radio/charger.
Power/Volume Adjustment
1. To turn the radio on and off, press the ON/OFF
button .
1
2. Turn the dial 2 clockwise to increase the volume. To
decrease the volume, turn counterclockwise.
Note the volume can also be muted by pressing the
mute button 9 .

Mode Function

To choose one of the mode functions (FM1, FM2, AM, AUX
or Bluetooth) push the mode button
function is found.
nOTE: Pressing the Bluetooth button
radio into Bluetooth mode.
Tune or Seek Function
There are two tuning methods and one seek method for
finding the desired frequency.
To tune:
Press and release the right or left arrow button
until the desired frequency is found.
To seek:
Press and hold the right or left arrow button
seconds. The tuner frequency will change to the first radio
station with acceptable clarity and stop at that station.
nOTE: When the radio/charger is paired to a Bluetooth®
device the right and left arrow buttons
skip or go to previous tracks on the audio device.
To Program the Clock
1. Power on the radio.
2. Press the clock button. The date and time will be
displayed, and the year will begin to blink.
3. Use the clock button to pick the parameter of time
desired and use the right and left arrows to adjust.
nOTE: If you do not press a button within 5 seconds,
the clock programming feature will automatically return
to the previous setting.
To Program the Memory Buttons
Ten FM and five AM radio stations may be independently
set. After programming the buttons, pressing 1, 2, 3, 4 or 5
will instantly change the frequency to the preset station.
1. Turn power on.
2. Set the radio to desired station (see Tune or seek
Function).
English
6 until the desired
13 also puts the
5 . Repeat
5 for 2
can be used to
5
7