Hkoenig HK8 Manuel D'utilisation page 8

Blade assembly:
Fix the sealing ring on the blade assembly, put it into the through the hole of the jar bottom,
hold the half top of the blade tightly and turn bottom upside, use the fixing bracket to fix
the blade by turning clockwise. Doing oppositely to remove it from the jar. Do not miss the
blade sealing ring between the blade and the jar bottom.
Kneading shaft assembly:
Remove the blade, fix the kneading shaft the same way as fixing the blade. It can be used
for kneading, or stirring and mixing without cutting the food.
Do not use it for speed over 3, otherwise it will cause big vibration to the machine and cause risk.
•
As the smallest distance between the stirring assembly and the jar wall is only 1cm, sometimes the
•
food may stuck and the motor may stop for self protection. Use the spatula to mix and remove the
stuck and it will be smoothly working again.
• Please make surethat the fixing bracket and the sealing ring is in place and locked tightly with blade
assembly. If the sealing ring isn't well placed, the food beingmixed or cooked may leak out and
damage theappliance
• The blade is very sharp. Please wrap the blade with washcloth when
assembling or removing the blade base.
Please hold the blade assembly firmly and take it out carefully so as
•
to ensure that blade assembly will not fall down and cause danger.
Please make sure that the fixing bracket and the sealing ring is in
•
place and locked tightly with blade assembly. If the sealing ring isn't
well placed, the food being mixed or cooked may leak out and
damage theappliance.
Notice
Notice