AEG A83400HLW0 Notice D'utilisation page 15

Problem
The High temperature
alarm light is on.
There is too much frost
and ice.
The lid doesn't close com-
pletely.
The lid is difficult to
open.
The lamp does not work.
It is too warm in the
freezer.
Possible cause
It is too warm inside the freez-
er.
The cabinet has been recently
switched on and the tempera-
ture is still too high.
Products are not wrapped
properly.
The lid is not shut properly or
do not close tightly.
The temperature is not set cor-
rectly.
The water drainage plug is not
correctly positioned.
There is excessive frost.
The lid gaskets are dirty or
sticky.
Food packages are blocking the
lid.
The lid gaskets are dirty or
sticky.
The valve is blocked.
The lamp is defective.
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly.
Before freezing the appliance
was not precooled sufficiently.
Large quantities of food to be
frozen were put in at the same
time.
Food placed in the appliance
was too warm.
Products to be frozen are
placed too closely to each oth-
er.
What to do if...
Solution
Refer to "High Temperature
Alarm".
Refer to "High Temperature
Alarm".
Wrap the products better.
Check if the lid closes well and
the gaskets are undamaged and
clean.
Set a warmer temperature.
Position the water drainage plug
in the correct way.
Eliminate excess frost.
Clean the lid gaskets.
Arrange the packages in the
right way, see the sticker in the
appliance.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the lamp".
Set a lower temperature.
Check if the lid closes well and
the gasket is undamaged and
clean.
Pre-cool the appliance for
enough time.
Wait some hours and then check
the temperature again. Next
time insert smaller quantities of
food to be frozen at any one
time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them.
15