Initial Setup; Before You Start; Network Setting - Pioneer N-70A-K Guide Rapide

Initial Setup

Before you start

1
Loading the batteries.
WARNING
• Do not use or store batteries in direct sunlight
or other excessively hot place, such as
inside a car or near a heater. This can cause
batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance
of batteries.
CAUTION
• When disposing of used batteries, please
comply with governmental regulations or
environmental public institution's rules that
apply in your country/area.
2
Switch on your system components and
this unit.
Start by switching on the playback component,
then this unit (press u/I STANDBY/ON button
on the front panel).
/I STANDBY/ON
STANDBY DIRECT Hi-Bit 32
5V 1A
iPod/iPhone
• The unit turns on. The button's central power
indicator will flash slowly.
About twenty seconds after turning on the
power, the following screen appears. About
thirty seconds are required between turning
the power on and completion of startup.

Network setting

Automatic setting
1
Press SETUP.
The Initial Setup screen is shown on the display.
2
Select Network Setting  Network
Configuration.
Network Setting
Network Configuration
Friendly Name
3
Use  to select DHCP On, then press
ENTER.
Select Don't Use Proxy Server.
Network Configration
DHCP On
DHCP Off
If your router does not support DHCP , please
manually set the network settings. Please see
the operating instructions on the enclosed CD-
ROM for more details.
Up Sampling
5
En