CDVI Digicode GALEO 4.0 Manuel D'installation page 16

INSTALLATION MANUAL
GALEO 4.0 Bluetooth
7] PROGRAMMING
A. FIRST USE OR AFTER RESET
1. Power up the system
On the remote electronics:
- Green LED lights on
- Then the Red LED lights on
On the keypad:
- 1 beep is emitted
2. Enter a new code twice for the master code (only 5 terms).
The 12345 code is forbidden in master code.
- Enter the second entry of the master code
- If both entry of the master code are the same, 2 beeps are emitted.
(about 10 seconds)
- Entry in programming mode
- Press B to exit from programming mode
B. RESET MEMORY
1. Cut off the power and put the jumper on P1.
- Refer to page 13 for the jumper P1 on the remote electronics
2. Put the power back :
On the remote electronics:
- Red LED lights on during reset
On the Keypad:
- 6 short beeps are emitted during reset and at the end 1 long beep is emitted
3. Pull out the jumper on P1
- Master code and user codes are cleared and set to default value
4. Start again from part A
16
cdvigroup.com
EN