CDVI Digicode GALEO 4.0 Manuel D'installation page 13

INSTALLATION MANUAL
GALEO 4.0 Bluetooth
P1
keypad to factory default
values. Remove the power
from the keypad then put
the jumper.
P2 jumper allows
to the user to modify
its own Pin code.
To enable this feature put
the jumper on.
Alimentation
Recommended
Power Suply
Outputs Wiring table
Input voltage 12V to 24VAC or 12V to 48VDC
V
INPUT
Input voltage 12V to 24VAC or 12V to 48VDC
V
NC N/C contact relay 1
DOOR 1 C Common relay 1
N/O contact relay 1
NO
N/C contact relay 2
NC
DOOR 2 C Common relay 2
NO N/O contact relay 2
N/C contact relay 3
NC
DOOR 3 Common relay 3
C
NO N/O contact relay 3
PB1 Request-to-exit input relay 1
Push
Common of inputs
M
button
Request-to-exit input relay 2
PB2
PX Not used
Not used
Clock H
Timer Contact
H
+ White wire from keypad
Keypad
- Brown wire from keypad
TMGALEO
Green or Blue wire (illumination)
E
jumper resets the
230 V AC
préconisée
12 VDC
ADC335
Alimentation
Input voltage
12V / 24V AC
12V / 48V DC
PB1 request-to-exit input activates relay 1.
PB2 request-to-exit input activates relay 2.
Latch or toggled output.
H input can be used with a timer to enable
free access by pressing on any digit key on
the keypad.
When the contact is open
then the request-to-enter is disabled.
When the contact is closed then press any
key on the keypad to enter.
EN
P2 P1
BP1 BP2
PB1 PB2
13
cdvigroup.com